SECTION 1 1.1 Product identifier Trade name GREENLOOP HD NEUTRAL Product form Mixture 1.2 Relevant identified uses and uses advised against Relevant identified uses: Industrial and professional degreasing and cleaning of oils, grease, machining fluids and technical contamination from metal and other resistant industrial surfaces. Uses advised against: Consumer use; use on surfaces not demonstrated to be chemically resistant; mixing with other cleaning agents or chemicals. 1.3 Details of the supplier of the safety data sheet Manufactured for Greenloop Industries Ltd., London, United Kingdom Manufacturer VIAMAK Sp. z o.o., ul. Grzybowska 80/82/700, 00-844 Warsaw, Poland Email / SDS contact office@viamak.pl 1.4 Emergency telephone number 112 (European emergency number). Medical personnel should contact the competent national poison information service.

SECTION 2 2.1 Classification of the mixture Classification according to Regulation (EC) No 1272/2008 (CLP): Skin Irrit. 2 — H315: Causes skin irritation. Eye Dam. 1 — H318: Causes serious eye damage. 2.2 Label elements GHS pictograms: GHS05 – Corrosion | GHS07 – Exclamation mark Signal word: DANGER Hazard statements: H315 Causes skin irritation. H318 Causes serious eye damage. Precautionary statements: P264 Wash hands and exposed skin thoroughly after handling. P280 Wear protective gloves and eye/face protection. P302+P352 IF ON SKIN: Wash with plenty of water. P305+P351+P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses if present and easy to do. Continue rinsing. P310 Immediately call a POISON CENTRE/doctor. P332+P313 If skin irritation occurs: Get medical advice/attention. P362+P364 Take off contaminated clothing and wash it before reuse. 2.3 Other hazards No PBT or vPvB substances at ≥0.1%. No endocrine-disrupting components at ≥0.1%. Spilled product may make floors slippery.

SECTION 3 3.2 Mixtures The exact formulation is proprietary. Substances disclosed per REACH Annex II. Concentrations stated as ranges. Substance CAS No. EC No. Content Classification (CLP) Alcohols, C10, ethoxylated (non-ionic surfactant) 160875-66-1 — 5–<10% Acute Tox. 4 H302; Skin Irrit. 2 H315; Eye Dam. 1 H318 Propylene carbonate (cyclic carbonate solvent) 108-32-7 203-572-1 20–<30% Eye Irrit. 2, H319 Dipropylene glycol monomethyl ether 34590-94-8 252-104-2 5–<10% Not classified under CLP; Union indicative OEL applies For full text of hazard statements, see Section 16. Phenoxyethanol is present at approximately 0.5% as a preservative and is below the general Section 3 disclosure threshold for this mixture.

SECTION 4 4.1 Description of first-aid measures Route First-aid measure General Remove contaminated clothing. Do not leave an affected person unattended. Inhalation Move to fresh air. Keep at rest. Obtain medical advice if symptoms occur or persist. Skin contact Wash immediately with plenty of water and soap. Remove contaminated clothing. Seek medical advice if irritation develops or persists. Eye contact Rinse cautiously with clean water for at least 15 minutes. Remove contact lenses if present and easy to do. Continue rinsing. Immediately call a poison centre or physician. Ingestion Rinse mouth. Do not induce vomiting. Never give anything by mouth to an unconscious person. Contact a poison centre or physician if unwell. 4.2 Most important symptoms and effects Skin irritation, redness and discomfort. Serious eye damage may occur, with pain, tearing, redness and risk of persistent ocular injury. 4.3 Immediate medical attention Treat symptomatically. Immediate medical, preferably ophthalmological, assessment is recommended after eye exposure.

SECTION 5 5.1 Extinguishing media Suitable: Water spray, alcohol-resistant foam, dry chemical or carbon dioxide. Unsuitable: Direct high-pressure water jet. 5.2 Special hazards Product is water-based and not classified as flammable. Heating or fire may generate CO, CO₂ and irritating organic fumes. 5.3 Advice for firefighters Wear self-contained breathing apparatus and full protective equipment. Cool exposed containers with water spray. Prevent contaminated firefighting water from entering drains or surface water.

SECTION 6 6.1 Personal precautions Avoid contact with skin and eyes. Provide ventilation. Wear protective gloves and tightly fitting eye/face protection. Mark and isolate slippery areas. Avoid aerosol formation. 6.2 Environmental precautions Prevent large quantities from entering drains, soil or surface water. Notify the competent authority if a significant environmental release occurs. 6.3 Methods and material for containment and cleaning up Contain the spill. Absorb with inert material (sand, universal binder or diatomaceous earth). Collect in a suitable labelled container. Wash residual contamination with water while preventing uncontrolled discharge. 6.4 Reference to other sections See Sections 8 and 13.

SECTION 7 7.1 Precautions for safe handling Use with adequate ventilation. Avoid splashing, aerosol formation and contact with skin and eyes. Do not eat, drink or smoke while handling. Wash hands after use. Do not mix with other cleaning chemicals. 7.2 Conditions for safe storage, including any incompatibilities Keep tightly closed in the original container at +5°C to +25°C. Protect from direct sunlight, excessive heat, freezing and contamination. Keep away from strong oxidising agents, strong acids and strong alkalis. Store separately from food and feed. 7.3 Specific end use(s) Industrial and professional degreasing. Follow the product label, operating instructions and material-compatibility testing requirements.

SECTION 8 8.1 Control parameters Substance Limit Reference Dipropylene glycol monomethyl ether (CAS 34590-94-8) 8-hour TWA: 50 ppm / 308 mg/m³; skin notation EU indicative OEL Other components Observe applicable national workplace limits National legislation / supplier SDS 8.2 Exposure controls Control Recommendation Engineering controls Provide general ventilation. Use local exhaust where spraying or mist formation is possible. Eye/face protection Chemical splash goggles. Add a face shield where splashing is likely. Hand protection Chemical-resistant gloves (e.g. nitrile rubber). Select material, thickness and breakthrough time per task and glove-supplier data. Skin/body protection Chemical-resistant work clothing. Remove and wash contaminated clothing before reuse. Respiratory protection Normally not required with adequate ventilation. For spraying or insufficient ventilation, use protection suitable for organic vapours and particulates. Environmental controls Minimise release to drains, soil and surface water.

SECTION 9 9.1 Information on basic physical and chemical properties Property Value Physical state Liquid Colour Clear to slightly opalescent; colourless to pale Odour Low odour Melting/freezing point Approx. −15°C Boiling point / boiling range Not determined for the mixture Flammability Not classified as flammable Lower/upper explosion limits Not applicable / not determined Flash point Approx. 100°C; >93°C, closed cup Auto-ignition temperature Not determined Decomposition temperature Not determined pH 6.5–7.5 at 20°C; typical value approx. 7.0 Kinematic viscosity at 40°C Approx. 2.8 mm²/s (range: 2.5–3.0 mm²/s) Solubility Dispersible/miscible with water Partition coefficient n-octanol/water Not applicable to the mixture Vapour pressure Not determined Density / relative density 1.03–1.07 g/cm³ at 20°C; typical approx. 1.045 g/cm³ Relative vapour density Not determined Particle characteristics Not applicable 9.2 Other information Freezing / application temperature: approx. −15°C.

SECTION 10 10.1 Reactivity — No hazardous reaction expected under normal conditions of storage and use. 10.2 Chemical stability — Stable under the recommended storage conditions. 10.3 Possibility of hazardous reactions — Hazardous polymerisation not expected. Mixing with incompatible cleaning chemicals may cause heat generation, splashing or irritating vapours. 10.4 Conditions to avoid — Excessive heat, freezing, direct sunlight, contamination and aerosol generation. 10.5 Incompatible materials — Strong oxidising agents, strong acids and strong alkalis. 10.6 Hazardous decomposition products — CO, CO₂ and irritating organic decomposition products may form during fire or severe overheating.

SECTION 11 11.1 Information on hazard classes as defined in Regulation (EC) No 1272/2008 Hazard class Assessment Acute toxicity Not classified on the basis of available component data and concentration calculations. Skin corrosion/irritation Skin Irrit. 2. Causes skin irritation. Serious eye damage/irritation Eye Dam. 1. Causes serious eye damage. Respiratory or skin sensitisation Not classified based on available information. Germ cell mutagenicity Not classified based on available information. Carcinogenicity Not classified based on available information. Reproductive toxicity Not classified based on available information. STOT — single exposure Not classified based on available information. STOT — repeated exposure Not classified based on available information. Aspiration hazard Not classified based on available information. 11.2 Information on other hazards No mixture-specific toxicological test data are available. No component is known to have endocrine-disrupting properties at a concentration of ≥0.1%.

SECTION 12 12.1 Toxicity — The mixture is not classified as hazardous to the aquatic environment on the basis of available ingredient data and concentrations. Avoid uncontrolled release. 12.2 Persistence and degradability — The surfactant and major organic components are expected to be biodegradable. No finished-product biodegradation test data are available. 12.3 Bioaccumulative potential — No significant bioaccumulation expected for the major water-miscible solvents. No mixture-specific data available. 12.4 Mobility in soil — The mixture is water-dispersible and may be mobile in soil. 12.5 Results of PBT and vPvB assessment — The mixture is not expected to contain components meeting PBT or vPvB criteria at concentrations of ≥0.1%. 12.6 Endocrine-disrupting properties — No component is identified as having endocrine-disrupting properties at a concentration of ≥0.1% on the basis of currently available information. 12.7 Other adverse effects — Large releases may adversely affect wastewater-treatment processes and local water quality.

SECTION 13 13.1 Waste treatment methods Dispose of product residues and contaminated absorbents through an authorised waste contractor in accordance with national and local regulations. Do not discharge concentrated product to drains. Empty packaging should be drained and recycled or disposed of according to local requirements. The waste producer is responsible for assigning the correct waste code according to the actual use and contamination.

SECTION 14 Item Information 14.1 UN number or ID number Not applicable 14.2 UN proper shipping name Not applicable 14.3 Transport hazard class(es) Not regulated 14.4 Packing group Not applicable 14.5 Environmental hazards No 14.6 Special precautions for user Keep containers upright, tightly closed and protected from damage. 14.7 Maritime transport in bulk (IMO) Not intended for transport in bulk The product is not classified as dangerous goods under ADR/RID, ADN, IMDG or ICAO/IATA on the basis of the current formulation and flash point data.

SECTION 15 15.1 Safety, health and environmental regulations/legislation specific for the mixture Regulation (EC) No 1907/2006 (REACH), including Annex II as amended by Regulation (EU) 2020/878. Regulation (EC) No 1272/2008 (CLP), as amended. Regulation (EC) No 648/2004 on detergents, as amended: contains 5–<10% non-ionic surfactants; preservative: phenoxyethanol. Applicable national occupational safety, waste and water-protection legislation. 15.2 Chemical safety assessment A chemical safety assessment has not been carried out for the mixture.